Just disconnect the actuator motor from the main wiring harness. Plug in the STV Eliminator and the unit will act as the actuator motor would still be in place. No splicing or soldering required and the bike's wiring harness remains intact. It can't get any easier than this!
If the actuator motor fails (frequent issue on some bike models) it is much cheaper to replace it with the STVE than getting a new motor.
The STVE module is about the same size as the actuator motor it replaces.
Rugged design, encased in epoxy resin.
Only high-quality SMD components used.
Each unit is extensively tested prior to shipping.
Oil and water resistant (IP68).
Size: 59 x 35 x 17 mm.
Weight: 62 g (with wiring).
